Smeg P775PO Manual page 13

For operation on 380-415 V 3N
core cable (5 x 1,5 mm
This type of connection cannot be used for models with 5 plates.
For operation on 380-415 V 2N
four-core cable (4 x 2,5 mm
For operation on 220-240 V 3
core cable (4 x 2,5 mm
For operation on 220-240 V
core cable.
(3 x 2.5 mm
(3 x 4 mm
The cable end to be connected to the appliance must be provided with
an earth wire (yellow-green) at least 20 mm longer.
Read the connection layout plate underneath the appliance with care.
If the appliance you have purchased is not fitted with a mains power lead a power lead resistant to a
temperature of at least 90°C must be used.
Otherwise, the electrical safety of the appliance may be put at risk.
The manufacturer declines all responsibility for damage to persons or things caused by non-
observance of the above prescriptions or by interference with any part of the appliance.
Warning: pass the power cable through hole "A" and fit
the cable clamp plate after making the electrical
connection.
To fit the plate, simply use the provided bolts to secure it
under the casing as shown in the figure.
Warning: close the cable clamp after making the
electrical connection. Close the terminal board cover by
twisting it down.
30
Instructions for the installer
).
2
).
2
∼
).
2
∼
: use a H05RR-F / H05RN-F type three-
2
: cooking hob with 4 plates)
2
: cooking hob with 5 plates)
∼
: use a H05RRF / H05RN-F type five-
∼
: use a H05RR-F / H05RN-F type
: use a H05RR-F / H05RN-F type four-
TYPE 1 TERMINAL BOARD
TYPE 2 TERMINAL BOARD