Setting The Rinse Aid Dosage - Miele HG05 Operating Instructions Manual

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
If the "Adjust Automatic" programme
option (depending on model) has been
activated, the amount of rinse aid dis-
pensed in the Automatic programme
can be higher than that set.
If spots appear on crockery and glass-
ware:
 Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
 Decrease the rinse aid dosage.
Before using for the first time
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the Start button in and whilst
holding it in switch the dishwasher
on using the  button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
 Press the  button 3 times.
The  indicator will flash rapidly 3
times at intervals.
The dosage set will show in the display
after the  symbol.
The flashing sequence   will appear in
the display.
This indicates the factory default setting
3.
 Use the Start button to select the set-
ting required.
Each press on the button moves you
up a level. After reaching the highest
value the counter starts from the be-
ginning again.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.
27