Toshiba RAS-077SKV-E7 Service Manual page 84

11-10. How to setting the CLEAN OPERATION cancel
11-10-1. Self-Cleaning
function
Operation display
FCU fan
FCU louver
Timer display
depend on presetting of timer function.
Compressor
depend on presetting per room temperature.
CDU fan
depend on presetting per room temperature.
operation more than 10 mins.
11-10-2. Self-Cleaning function release
How to set/cancel Self-Cleaning function
To set/cancel the Self-Cleaning function, proceed as
follows:
• Setting diagnosis code "06" on remote controller
(See detail of setting diagnosis code in 11-4-1)
• Turn on the poert supply to air conditioner,
after that press [RESET] button on air conditioner
1 time to turn on the air conditioner (The LED
display will show in green color) (Fig. 11-10-1)
•
Take the remote controller to direction of LED
display on air conditioner, press [ TEMP ] of
the remote controller (Fig. 11-10-2) 1 time
to send the code "07", then air conditioner will
shutdown automatically. Also, LED display will
show flash follow the able below.
Self-cleaning
Operation LED
function
flash 1 Hz
ON
flash 1 Hz
OFF
Note) Table above will show current status of
Self-Cleaning function
• Self-Cleaning diagram
ON
ON
rpm is depend on presetting.
OPEN
ON or OFF
ON or OFF
ON or OFF
Cool mode or dry mode
Turn off by remote controller or
timer-off function.
Timer LED
not flash
Flash 1 Hz
OFF
ON
(500RPM)
OPEN (12.7º)
ON
OFF
OFF
Self-Cleaning mode
operate 20 mins.
Automatically turn-off.
•
Set or Cancel Self-Cleaning function by push
the RESET button at LED display.
When setting is changed, the sound warning will
alarm "Beep". The setting is changed following
below.
ON
•
Turn on air conditioner again by remote controller
to confirm setting.
– 83 –
FILE NO. SVM-15004
OFF
OFF
CLOSE
ON or OFF
depend on presetting of timer function.
OFF
OFF
Operation time
OFF
ON
OFF
RESET
RESET button
Fig. 11-10-1
Fig. 11-10-2