Safety Notices; Product Safety Certification; Safety Warning - Watchguard AP102 Hardware Manual

Safety Notices

All WatchGuard products are designed and tested to meet strict safety requirements. These requirements
include product safety approvals and other global compliance standards. Read these instructions carefully
before you operate the product, and refer to them as needed for continued safe operation of your product.

Product Safety Certification

The WatchGuard product is safety certified under the following standards:

CAN/CSA C22.2 No.60950-1-07+A1:2011

IEC 60950-22 1st Edition

UL 60950-1:2007 R12.11

EN 60950-1:2006+A11+A1+A12 (2nd Edition)

EN 60950-22:2006 (Annex D.2 & D.3) Gasket and O-ring must be properly installed

Safety Warning


Do not place objects on the power cord.

Do not obstruct the ventilation openings. These openings prevent overheating of the machine.

Never push objects of any kind into slots or openings on this equipment. Making a contact with a
voltage point or shorting out a part may result in fire or electrical shock.

When removing or installing the device, follow the general installation safety instructions.
Disclaimer
WatchGuard shall not be held liable if the end user alters, modifies, or repairs any WatchGuard hardware
appliance.
Hardware Guide
Hardware Specifications
9