Included In This Package; Battery Removal And Installation - VTech Switch & Go Dinos Spark the Velociraptor Parents' Manual

INCLUDED IN THIS PACKAGE

SWITCH & GO DINOS
•
• Parent's Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child's safety.
NOTE
Please keep this parent's guide as it contains important information.
INSTRUCTIONS

BATTERY REMOVAL AND INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit. Use a
screwdriver to loosen the screw. Then, remove the cover.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance).
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
Spark the Velociraptor
®
3