Turning Off The Power - Hitachi MP-AW4001 User Manual

NOTE • The ASPECT button does not work when no proper signal is input.
an operation is made. This is not a malfunction.

Turning off the power

1.
Press the STANDBY/ON button on the
projector or the remote control.
The message "Power off?" will appear on
the screen for about 5 seconds.
2.
Press the STANDBY/ON button again while
the message appears.
The light source will go off, and the POWER/
STATUS1 indicator will begin blinking in
orange. Then the POWER/STATUS1 indicator
will stop blinking and light in steady orange
when the light source cooling is completed.
WARNING
use, since it is too hot.
be close to the projector and easily accessible.
NOTE • Please power off the projector after any connected devices are
powered off.
( 1)
14
1)
(
POWER/STATUS1 indicator
STANDBY/ON button
MYBUTTON
INPUT
ASPECT PbyP AUTO FREEZE
MAGNIFY FOCUS ZOOM VOLUME
ON
OFF
PAGE
UP GEOMETRY PICTURE MUTE
DOWN INTERACTIVE NETWORK BLANK
ESC MENU
ENTER
OSD MSG RESET