Turning On The Power - Hitachi MP-AW4001 User Manual

Turning on the power

1.
and correctly connected to the projector
and the outlet.
2.
Make sure that the POWER/STATUS1
indicator is steady orange.
3.
Press the STANDBY/ON button on the
projector or the remote control.
The projection light source will light up,
and the
POWER/STATUS1
blinking in green.
When the power is completely on, the
indicator will stop blinking and light in steady green.
WARNING
projection light source is on, since the projection ray may cause a
trouble on your eyes.
right. It could cause malfunction or injury. If you install the projector
vertically on a table or desk, be sure to use the designated optional
accessories.
be damaged by excessive force or an impact. Read the following
important warnings carefully, and follow them for your own safety.
• Do not apply excessive force on or allow impact to the projection
window.
• Keep the projector out of the reach of children.
• If the projection window is broken, the projected image will be
distorted. Never touch a broken projection window, and contact your
dealer.
NOTE • Please power on the projector prior to the connected devices.
• The projector has the DIRECT POWER ON function, which can make the
1)
Guide". (
indicator will begin
Never look into the projection window while the
POWER/STATUS1 indicator
STANDBY/ON button
MYBUTTON
INPUT
ASPECT PbyP AUTO FREEZE
MAGNIFY FOCUS ZOOM VOLUME
ON
OFF
PAGE
UP GEOMETRY PICTURE MUTE
DOWN INTERACTIVE NETWORK BLANK
ESC MENU
ENTER
OSD MSG RESET
11