Table of Contents
Advertisement
Available languages
Available languages
TO INSTALL BLADE INTO SAW (FIG. 9A, 9B, 9C)
1. Pull blade clamp release lever (G) up.
2. Insert the blade shank into the blade clamp (F, Fig. 9C).
3. Close blade clamp release lever.
4. Note that the blade can be installed upside-down to assist in
flush-to cutting (refer to Fig. 9B).
TO REMOVE BLADE FROM SAW (FIG. 9A, 9B, 9C)
CAUTION: Burn hazard. Do not touch the the blade immediately
after use. Contact with the blade may result in personal injury.
1. Pull blade clamp release lever (G) up.
2. Remove blade.
FIG. 9A
G
FIG. 9B
FLUSH-TO CUTTING
Worklight (Fig. 9C)
The worklight (E) is located below the blade clamp (F) behind the shoe
The worklight will be activated when the trigger switch is squeezed.
NOTE: The worklight is for lighting the immediate work surface and
is not intended to be used as a flashlight.
Cutting (Fig. 9, 10–13)
WARNING: Always use eye protection. All users and bystanders
must wear eye protection that conforms to ANSI Z87.1.
WARNING: Exercise extra caution when cutting towards operator.
Always hold saw firmly with both hands while cutting.
Before cutting any type of material, be sure it is firmly anchored or
clamped to prevent slipping. Place blade lightly against work to be
FIG. 9C
cut, switch on saw motor and allow it to obtain maximum speed
F
before applying pressure. Whenever possible, the saw shoe must be
held firmly against the material being cut. This will prevent the saw
from jumping or vibrating and minimize blade breakage. Any cuts
E
which put pressure on the blade such as angle or scroll cuts increase
potential for vibration, kickback, and blade breakage.
WARNING: Use extra caution when cutting overhead and pay
particular attention to overhead wires which may be hidden from view.
Anticipate the path of falling branches and debris ahead of time.
WARNING: Inspect work site for hidden gas pipes, water pipes,
or electrical wires before making blind or plunge cuts. Failure to do
so may result in explosion, property damage, electric shock, and/or
serious personal injury.
12
Advertisement
Table of Contents
