GE Advantium ZSC1202 Installation Instructions Manual page 4

Convection ovens
Hide thumbs Also See for Advantium ZSC1202:
Table of Contents

Advertisement

Available languages

Available languages

ELECTRICAL REQUIREMENTS
Single Advantium/Convection 120
Installation:
This product requires a 120-volt, 60 Hz, 15-amp
circuit and draws 1.8 kilowatts. This product must
be connected to a supply circuit of the proper
voltage and frequency.
• Wire size must conform to the requirements of
the National Electrical Code or the prevailing local
code for this kilowatt rating.
• The power supply cord and plug should be
brought to a separate 15 or 20 ampere branch
circuit single grounded receptacle. The outlet box
should be located within reach of the 48" power
cord.
ELECTRICAL LOCATION
Locate outlet box in the shaded area
Install a recessed electrical outlet in the back
wall of the opening within 6 of either side and
at least 9 above the cutout floor.
Installation Preparation
6"
9"
GROUNDING
INSTRUCTIONS
This appliance must be grounded. In the event of
an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire
for electric current. This appliance is equipped
with a cord having a grounding wire with a
grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded.
WARNING
Improper use of the
grounding plug can result in a risk of
electric shock.
IMPORTANT:
(Please read carefully).
The power cord of this appliance is equipped with
a three-prong (grounding) plug that mates with a
standard three-prong grounding wall receptacle
to minimize the possibility of electric shock.
Consult a qualified electrician or serviceman if
the grounding instructions are not completely
understood, or if doubt exists as to whether the
appliance is properly grounded.
• Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the consumer to have it replaced with
a properly grounded three-prong wall receptacle.
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
DO NOT USE AN EXTENSION CORD. If the
power supply cord is too short, have a qualified
electrician or serviceman install an outlet near the
appliance.
4

Advertisement

Chapters

Table of Contents
loading

Table of Contents