Table of Contents
Advertisement
When you change a setup, a part of the screen shows the
choices. Use WXYZ to access the menu choices.
Connect-and-View™
The Connect-and-View™ function (Auto Set) enables
hands-off operation to display complex unknown signals.
This function optimizes the position, range, time base,
and triggering to ensure a stable display on most
waveforms. The setup will track the changes if the signal
changes. This feature is enabled by default.
To enable the Connect-and-View™ function when in
Manual mode:
1.
Connect the red test lead from red input A to the
unknown signal to be measured.
2.
Push to toggle between the Auto (automatic) and
Manual modes.
In Figure 6 the screen displays "1.234" in large numbers
and "50.00" in smaller numbers. A scope trace gives a
graphical representation of the waveform.
The trace identifier is visible at the left side of the
waveform area. The zero icon (-) identifies the ground
level of the waveform.
sales@GlobalTestSupply.com
Measurements
The reading area shows the numeric readings of the
chosen measurements on the waveform that is applied to
the input jack. Figure 7, Figure 8, and Figure 9 illustrate
the setups for measurements.
Fluke-Direct
Industrial ScopeMeter®
Scope and Meter Mode
Figure 6. Auto Set Function
.com
1.888.610.7664
hxv55.eps
15
Advertisement
Table of Contents
