Table of Contents
Advertisement
WARNING:
• Hazardous electrical
voltages can be
present on any
connected wiring.
USB wiring and
connections must be
properly insulated to
prevent electrical
shock. Disconnect
power from the
cable modem before
attempting to
connect to any
device.
• To avoid personal
injury, follow these
steps in the exact
order shown.
CAUTION:
To prevent possible
damage to the
equipment, disconnect
any other service
before connecting
your cable modem to
other devices.
To connect USB devices
Read the warnings and caution on this page. Then, follow the subsequent
installation procedures to ensure proper cable modem operation when
connecting USB network devices.
Note: Verify that you have installed the USB drivers on your PC before
continuing with these instructions. See How Do I Install USB Drivers, earlier in
this guide, for more information on installing the USB drivers.
1.
Select locations for USB network devices. For more information, see
How Do I Select and Place USB Network Devices, earlier in this guide.
2.
Connect the USB port on the cable modem to your computer.
3.
Connect one or more USB network device to the cable modem.
Note: If you want to connect more than one USB network device to the
cable modem or to your computer, you will need to purchase and install a
USB hub.
4.
Connect the active RF coaxial cable to the CABLE connector on the back
of the cable modem. Use an optional cable signal splitter to add a TV, a
DHCT or set-top converter, or a VCR.
5.
After all connections are complete, insert the AC power cord into the
POWER connector on the back of the cable modem, and then plug the
cord into an AC power source.
6.
The cable modem begins an automatic search to locate and sign on to
the network that provides the telephone service. This process may take
up to 5 minutes. The cable modem is ready for use when the CABLE
status indicator on the front panel stops blinking and illuminates
continuously.
7.
Verify that all USB devices are working properly.
Note: You will not be able to check the front panel LED status indicator
on the cable modem until after at least one USB network device is
connected and operating on the network.
How Do I Connect USB Network Devices?
27
Advertisement
Table of Contents
