Disassembly/Assembly Procedures - Bose AmPlus 50 Supplement Manual

DISASSEMBLY/ASSEMBLY PROCEDURES

Installation Instructions
1. Opti-Voice ® Page and Opti-Source™
Option Cards
Note: Refer to Figures 1 and 2 for the
following procedures.
Figure 1. AmPlus™ 100 Rear Panel
1.1 Facing the rear of the AmPlus 100
Amplifier, remove the two screws that
secure the cover plate for the option card
slot that you wish to use.
Note: If you have both an Opti-Voice Page
and an Opti-Source Option Card, you must
install the Source card into the left slot,
because of the music "ducking" feature of
the Page card.
Figure 2. Option Card Installation
1.2 Slide the Option Card into the card
cage until it engages with the connector.
1.3 Secure the Option Card to the amplifier
with the two screws removed in step 1.1.
®
2. FreeSpace
Model 25/32 Equalizer Cards
Note: Refer to Figures 3, 4 and 5 for the
following procedures.
Figure 3. Top Cover Removal
2.1 Using a phillips-head screwdriver,
remove the five screws that secure the
AmPlus amplifier top cover to the amplifier
chassis.
2.2 Lift the AmPlus amplifier top cover
straight off.
EQ CARD 1
EQ CARD 2
Figure 4. EQ Card Installation
2.3 On the Main PCB, you will see two
jacks marked J9 and J10. (On the AmPlus
50 amplifer you will see only J9).
2.4 Plug the EQ Card into either J9 or
J10, as appropriate for your installation,
until it is fully engaged into the connector.
11
Model 1B, Model 8, and
EQ CARD 1
EQ CARD 2
J9
J10