Changing The Bluetooth Settings - JVC KD-R721BT Instructions Manual

Changing the Bluetooth settings

1
2
] <BLUETOOTH>
Menu item
1
CONNECT PH*
CONNECT AU
DISCONNT PH/
DISCONNT AU
DELETE PAIR
P. BOOK WAIT
SET PINCODE
AUTO CNNCT
INITIALIZE
INFORMATION
* 1
Will not display if two Bluetooth phones are connected at the same time.
* 2
Displayed only when a Bluetooth phone/audio player is connected.
18 ENGLISH
[Hold]
Selectable setting, [ Initial: Underlined ]
Turn the control dial to select a device you want to connect. "CONNECTED" = "[Device Name]"
/
scrolls on the display when the device is connected.
Turn the control dial to select a device you want to disconnect. "DISCONNECT" =
"[Device Name]" scrolls on the display when the device is disconnected.
Turn the control dial to select the device you want to delete, then press the control dial to confirm.
DELETE YES : Confirm to delete the selected device. / DELETE NO : Cancels.
You can copy the phonebook memory of a mobile phone into the unit (via OPP). You may need
to enter the PIN code or verify passkey from the mobile phone to do pairing. You can transfer a
maximum of 400 numbers.
You can change the PIN code of your choice before pairing (1-digit to 6-digit number).
[ Initial: 0000 ]
Turn the control dial to select a number, press 4
then press the control dial to confirm the entry.
ON : The connection is established automatically with the registered Bluetooth device when
you turn on the unit. / OFF : The unit does not connect the Bluetooth device automatically. Use
<CONNECT PH/ CONNECT AU> to connect.
YES : Initialize all the Bluetooth settings (including stored pairing, phonebook, and etc.). /
NO : Cancels.
PH CNNT DEV * 2 : Shows connected phone name. / AU CNNT DEV *
connected audio device name. / MY BT NAME : Shows the unit name (JVC Unit). /
MY ADDRESS : Shows address of USB Bluetooth Adapter.
3
Repeat step 2 to select a setting item (see
table below), then repeat the procedure
to change the setting accordingly.
• To return to the previous menu, press
T/P BACK.
• To exit from the menu, press MENU.
/¢ to move to the entry position,
2 : Shows