Preparing The System; Saving Power - Sony ZS-2000 Service Manual

Setting Up
Preparing the
system
According to the illustrations,
connect the cords firmly.
Wrong connections cause mal-
functions. Connect the mains
lead last.
Aerial unit
Note
1 Hooking up the aerial
Be sure to turn off the
power of the player
1
before connecting/
Strip the coating from the end of the cable and
disconnecting the
twist the wires.
mains lead.
Note 2
Connect the black wire to U and the white wire to
Keep the aerial unit
away as far as possible
from the player. If you
do not, noise may be
heard.
* Reorient the aerial unit to improve reception
GB
34
Setting Up
Preparing the system (continued)
Important
To improve the FM reception
When you use an
1 Connect the FM outdoor aerial (not supplied). If
outdoor aerial, be sure
to connect the U
terminal to earth
against lightning. To
prevent a gas
explosion, do not
connect the ground
wire to a gas pipe.
FM outdoor
aerial (not
supplied)
2 Set the FM ANTENNA SELECTOR at the rear to
To improve the MW/LW reception
Connect a 6- to 15-meter (20- to 50 feet) (not supplied)
insulated wire to the aerial unit terminal. Keep the
wire as horizontal as possible near the window or
outdoor. You do not need to disconnect the supplied
aerial unit.
GB
36
Setting Up
1
Aerial terminals
FM ANTENNA
2
SELECTOR to the mains
terminal.
Aerial unit*
(supplied)
Black
White
(see pages 4 and 9).
you use a distributor, you can also use the TV
aerial.
IEC standard socket
connector (not
supplied)
"EXT".
Insulated wire
Earth
(not supplied)
Tips
• The sound quality may
be changed depending
on the polarity of the
mains plug. Change the
direction of inserting
the plug and check the
sound quality.
• This unit is supplied
with a different colour
speaker net. If you wish
to change the colour of
your speaker, pull each
corner of the speaker
net toward yourself to
remove the net. Then
exchange it with the
extra net.

Saving power

Even when power is turned off, this
player consumes about 5.6 W for time
indication, timer operation, remote
control reception. If you use the saving
power function, you can reduce power
consumption to less than 1 W.
Earth
– 6 –
2 Connecting the mains lead
Connect the mains lead to the mains.
3 Inserting batteries into the remote
Insert two R6 (size AA) batteries (not supplied)
Replacing batteries
With normal use, the batteries should last for about
six months. When the remote no longer operates the
player, replace all the batteries with new ones.
DISPLAY
ENTER MEM
When the power is off, press and hold
DISPLAY•ENTER MEM for about 2 seconds.
The player enters the lower power consumption
standby mode.
To cancel the saving power
To make the time indication appear, press and hold
DISPLAY•ENTER MEM for about 2 seconds when the
power is off.
continued
GB
35
Setting Up
GB
37
Setting Up