Table of Contents
Advertisement
16
www.aeg.com
8.2 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
8.3 Temp.
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
and
the water.
8.4 Centrifugeren/Essorage
When you set a programme, the
appliance automatically sets the default
spin speed allowed.
Touch repeatedly this button to:
• Change the spin speed.
The display shows only
the spin speeds available
for the set programme.
• Activate the Rinse Hold option.
The final spin is not performed. The
water of the last rinse is not drained
out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum.
The display shows the indicator
The door stays locked and the drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
If you touch the Start/Pauze / Départ/
Pause button, the appliance performs
, the appliance does not heat
the spinning phase and drains the
water.
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the Extra Silent option.
The intermediate and the final
spinning phases are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
The display shows the indicator
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
If you touch the Start/Pauze / Départ/
Pause button, the appliance performs
the only draining phase.
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the drain-only option
(Skipping the wash, rinse and spin
phases): Pompen/Vidange.
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator
spin) and the indicator
• Activate the spin-only option
(Skipping the wash and rinse
phases): Centrifugeren/Essorage.
.
.
(no
.
Advertisement
Table of Contents
