18. ENVIRONMENTAL CONCERNS..............44 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
This appliance is intended to be used in household • and similar applications such as: staff kitchen areas in shops, offices and other – working environments; by clients in hotels, motels, bed & breakfast and – other residential type environments;...
Page 5
ENGLISH future they must be reattached to lock be replaced, this must be carried out the drum to prevent an internal by our Authorised Service Centre. damage. • Connect the mains plug to the mains • Always take care when moving the socket only at the end of the appliance as it is heavy.
Prewash such fabrics by hand before pressure switches, thermostats and loading them into the washing sensors, software and firmware machine. including reset software, door, door • Do not touch the glass door while a hinge and seals, other seals, door programme operates.
ENGLISH 3.2 Appliance overview 11 12 Worktop Drain hose Detergent dispenser Inlet hose connection Control panel Mains cable Door handle Transit bolts Rating plate Hose support Drain pump filter Feet for levelling the appliance The rating plate reports the model name (A), product number (B), electrical ratings (C) and serial number (D).
Level of protection against ingress of solid particles and IPX4 moisture ensured by the protective cover, except where the low voltage equipment has no protection against mois‐ ture Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 8 bar (0.8 MPa)
Page 9
ENGLISH 5. Carefully put the appliance down on It is possible to see its rear side. water flowing from the 6. Put the front polystyrene packaging drain hose. This is due element on the floor under the to the testing with water appliance.
Page 10
Make sure that carpets do not stop the air circulation below the appliance. Make sure that the appliance does not touch the wall or other units. 2. Loosen or tighten the feet to adjust the level. WARNING! Do not put cardboard, wood 5.3 The inlet hose...
Page 11
ENGLISH Make sure that the plastic Do not use an extension guide cannot move when the hose if the inlet hose is too appliance drains. short. Contact the service centre for the replacement of the inlet hose. 5.4 Water-stop device The inlet hose has a water stop device.
6. ACCESSORIES 6.1 Available in Only appropriate www.aeg.com/shop or from accessories approved by authorised dealer AEG ensure the safety standards of the appliance. If Read carefully the instructions supplied unapproved parts are used, with the accessory. any claims will be...
If you install the appliance on a plinth, using the correct stacking kit secure the appliance with the fixing manufactured and approved by AEG. plates. Verify the compatible Read carefully the instructions supplied stacking kit by checking the with the accessory.
Page 14
• Extra rinse option (Extra aclarado/ Spin reduction touch button (Centrif.) enxag.) • Skipping wash phase - Only • Rinse Hold option Rinse option (Aclarado/Enxag.) • Extra Silent option Start/Pause touch button (Inicio/ • Skipping wash and rinse phases - Pausa) Only Spin option (Centrif.)
ENGLISH Rinsing phase indicator. It flashes during rinse phase. When the Soft Plus option is activated, the indicator appears. Spinning and draining phase indicator. It flashes during spin and drain phase. Steam phase indicator. Anti-crease phase indicator. Child safety lock indicator. Time saving indicator.
Page 16
When the display shows the indicators The appliance empties the water out , the appliance does not heat automatically after 18 the water. hours approximately. 8.4 Centrif. • Activate the drain-only option (Skipping the wash, rinse and spin When you set a programme, the phases): Drenar.
Page 17
ENGLISH 8.7 Inicio Diferido This option is not available with a With this option you can delay the start of temperature lower than a programme in a more convenient time. 40 °C. Touch the button repeatedly to set the • Pre-lav. required delay.
This helps in removing 8.10 Anti-Alergia germs, bacteria, micro-organism and Set this option with white Algod. items particles. The addition of vapour together programme. When the option is selected, with an additional rinsing phase ensures neither the temperature or the cycle time a proper removal of detergent residues can be changed.
Page 19
ENGLISH Programme Programme description Vapor Cotton, synthetics and mixed items. Special steam cycle without washing that can be used to prepare your dried laundry for ironing or refreshing garments worn once . This pro‐ gramme reduces creases and odours and relaxes the fibres. When the programme is completed, quickly remove the laun‐...
Page 20
Programme Programme description Jeans Denim clothing and jersey items. Normal soiled. This pro‐ gramme performs a gentle rinsing phase, designed for denim, that reduces fading and does not cause washing powder resi‐ dues on the fibres. 1) During this cycle the drum rotates slowly to ensure a gentle wash. It can seem that the drum doesn't rotate or doesn't rotate properly, but this is normal for this programme.
Page 21
ENGLISH Programme Default tempera‐ Reference spin Maximum load ture speed Temperature Spin speed range range 40 °C 1200 rpm 8 kg 60 °C - Cold 1200 rpm - 400 rpm Jeans 1) According to Commission Regulation EU 2019/2023, this programme at 40 °C is able to clean normal‐ ly soiled cotton laundry declared to be washable at 40 °C or 60 °C, together in the same cycle.
Page 22
■ Anti-Alergia ■ ■ ■ ■ ■ ■ Extra Rápido ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Inicio Diferido ■ ■ ■ ■ Vapor Plus ■ ■ ■ ■ ■ ■ Soft Plus 1) Before setting this option, select a suitable washing programme for the garments. The appliance will performs the most fitting spin cycle for your garments care (e.g.
ENGLISH ▲ = Recommended -- = Not recommended 9.2 Woolmark Apparel Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine.
10.5 Soft Plus To activate/deactivate this option touch the Temp. button and the Centrif. button Set the Soft Plus option to optimise the simultaneously until the indicator fabric softener distribution and improve comes on/goes off above the the fabric softness.
Page 25
ENGLISH CAUTION! After a washing cycle, if Make sure that no laundry necessary, remove any stays between the seal and detergent residue from the the door. There is a risk of detergent dispenser. water leakage or damage to the laundry. 12.4 Check the position of the CAUTION! flap...
Page 26
The display shows the maximum declared load for the programme, the default temperature, the default spin speed, the washing phase indicators (when available) and an indicative programme duration. 2. To change the temperature and/or the spin speed, touch the related buttons.
Page 27
ENGLISH Cancelling the delay start In this case, for 30 seconds, it is possible to pause the appliance and remove the after the countdown has exceeding garments. started Once removed the exceeding garments, To cancel the delay start: touch the Inicio/Pausa button to start the programme again.
Page 28
If the temperature and level The steam phase is running: of the water in the drum are too high and/or the drum still The anti-crease phase is running: rotates you cannot open the door. 1. Touch the button Inicio/Pausa.
ENGLISH 12.14 Draining water out after 4. Press the On/Off button a few seconds to deactivate the appliance. end of cycle In any case, the appliance If you have chosen a programme or an empties the water out option that does not empty out the water automatically after of the last rinse, the programme is approximately 18 hours.
Page 30
Inicio/Pausa button. The spin phase continues. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts, cords, shoelaces, ribbons and any other loose elements.
ENGLISH • mould in the appliance. suggested by the detergent producer and check the water hardness of you Excessive detergent may cause: domestic system. Refer to 'Water • sudsing, hardness'. • reduced washing effect, • Set the maximum possible spin •...
Page 32
Remove any foreign objects (such as To eliminate these deposits and metal clip, buttons, coins, etc) that you hygienize the inner part of the appliance, may find in the door seal, the filters and run a maintenance wash regularly (at the drum.
Page 33
ENGLISH Always follow the instructions that you find on the packaging of the product. Do not clean the drum with acidic descaling products, scouring products containing chlorine or iron or steel. For a thorough clean: 1. Clean the drum with special products for stainless steel.
Page 34
Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code WARNING! •...
Page 35
ENGLISH occasionally to remove any deposit, collected over the time: 1. Remove the inlet hose from the tap and clean the filter. 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages.
14.12 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 37
ENGLISH With some problems, the display shows an alarm code and the Inicio/Pausa button may flash continuously: If the appliance is overloaded, remove some items from the drum and/or keep pressed the door while touching the Inicio/Pausa button until the indicator stops flashing (see the picture below).
Page 38
• The programme was not finished properly or the appliance stopped too early. Switch the appliance off and on again. Internal fail. No com‐ • If the alarm code appears again, contact the Authorised Serv‐ munication between ice Centre.
Page 39
ENGLISH Problem Possible solution • Make sure that a washing programme that ends with water in tub, has not been selected. • Make sure that the washing programme is finished. • Set the drain or the spin programme if there is water in the You cannot open the drum.
3. Open the filter flap. CAUTION! 4. Pull the emergency unlock trigger Risk of injury! Make sure downward once. Pull it downward that the drum is not once again, keep it tensed and, in the rotating. If necessary, wait meanwhile, open the appliance door.
Page 41
ENGLISH Remaining moisture at the end of spinning phase. The higher is the spin speed, the higher is the noise and the lower is the remaining moisture. Values and programme duration may differ depending on different conditions (e.g. room temperature, water temperature and pressure, load size and type of laundry, supply voltage) and also if you change the default setting of a programme.
Programme Litres h:mm °C Delicados 0.40 1:00 1200 30°C Lana/Lãs + Seda 0.20 1:05 1200 30°C 1) Reference indicator of the spin speed. 2) Suitable for washing heavily soiled textiles. 3) Suitable for washing lightly soiled cottons, synthetic and mixed fabrics.
Page 43
ENGLISH 17.2 Cleaning the drain pump filter 180˚ Clean the filter regularly and, especially, if the alarm code appears on the display. 17.3 Programmes Programmes Load Product description Eco 40-60 White and coloured cottons. Normally soiled 8 kg garments. Algod. 8 kg White cotton and coloured cotton.
18. ENVIRONMENTAL CONCERNS appliances marked with the symbol Recycle materials with the symbol with the household waste. Return the Put the packaging in relevant containers product to your local recycling facility or to recycle it. Help protect the contact your municipal office.