Yaesu FT-2500M Technical Supplement page 7

Install a Replacement Chip
As the value of some chip components is not
indicated on the body of the chip, be careful to
get the right part for replacement.
D
Apply a small amount of solder to the land
on one side where the chip is to be installed.
Avoid too much solder, which may cause
bridging (shorting to other parts).
D
Hold the chip with tweezers in the desired
position, and apply the soldering iron with
a motion line that indicated by the arrow in
the diagram below. Do not apply heat for
3
more than seconds.
D
Remove the tweezers and solder the elec­
trode on the other side in the manner just
described.
• ...., .. .,. ,.. _ ,.,._ - ._. ,. a " -
Chip Component Information
1 -5