LG Zenith H20J54DT Installation Manual & Warranty page 47

Installer Menu
Detailed Descriptions for Installer Menu Items 26-I through 53-I
26-I. NOT USED
27-I. HOSPITAL MODE
The default is 2 (which favors most hospitals).
With this setting two things are affected: Channel
Banks 1, 2 and 3 are accessible, while Bank 4 can
be made inactive by removing all the channels
from Channel Bank 4. Then, if Channel Bank 4 is
selected when the TV is turned on, the TV screen
will show "Inactive TV". The Channel Bank 4 setup
allows the hospital to present TV viewing options
to the patient. The patient can select programming
options available in either Bank 1, 2 or 3. Channel
Banks are available in all hospital modes.
• The IR code that will control the TV depends on
Item 20-I Feature Level setting.
Hosp. Mode = 0 Not hospital mode.
Hosp. Mode = 1 Zenith P.L. IR Code (Bed 1)
Hosp. Mode = 2 Zenith IR Code (Bed 2)
28-I. CH. OVER RIDE (Channel Override)
If set to 1, the user can select channels with
either Channel Up/Down or by direct keypad entry.
If set to 0, only those channels that are entered
for scanning may be selected by direct keypad
entry. Note: If set to 0, Auto Program is locked
out; (as shown on Setup menu) channel search
is not available.
29-I. OLD OCV (On Command Video
Set to 1 for operation with systems from On
Command Corporation.
30-I. ACK MASK
M.P.I. Communication Parameter. Leave at
default setting unless changed by Pay-Per-View
provider.
31-I. POLL RATE
M.P.I. Communication Parameter. Leave at default
setting unless changed by Pay-Per-View provider.
32-I. TIMING PULSE
M.P.I. Communication Parameter. Leave at default
setting unless changed by Pay-Per-View provider.
33-I. NOT USED
34-I. NOT USED
206-4065
35-I. NOT USED
36-I. NOT USED
37-I. NOT USED
38-I. NOT USED
39-I. REAR VIDEO EN. (Rear Video Enable)
Set to 1 to enable rear AUX (Video) input.
Set to 0 to disable rear AUX input.
40-I. NOT USED
41-I. NOT USED
42-I. NOT USED
43-I. NOT USED
44-I. NOT USED
45-I. NOT USED
46-I. NOT USED
47-I. AUX STATUS
Set to 1 for M.P.I. AUX source to be reported as a
channel number instead of channel 0. Set to 0 to
disable AUX identification change.
48-I. DIS SETUP M (Disable Setup Menu)
Set to 1 to disable the Setup menu. Setup menu
will not appear. Set to 0 to enable the Setup
TM ) menu.
49-I. NOT USED
50-I. DIS VIDEO M (Disable Video Menu)
Set to 1 to disable the Video menu. Video menu
will not appear. Set to 0 to enable the Video
menu.
51-I. DIS VCHIP M (Disable V-Chip Menu)
Set to 1 to disable V-Chip menu. V-Chip menu will
not appear. Set to 0 to enable the V-Chip menu.
52-I. NOT USED
53-I. DIS CH-TIME (Disable Channel-Time OSD)
Set to 1 to disable the Channel-Time display.
Channel-Time display will not appear.
Set to 0 to enable the Channel-Time display.
Page 47