Table of Contents
Advertisement
Connecting Up
2
Home theater video connections
This player outputs video in a number of different ways.
Choose the one most suitable for your system using the
guide below.
If your TV and projector have a DVI-D
terminal for Video Input, we recommend using
it to connect directly to the DVI-D out of this
player.
RS-232C
IN
OUT
REMOTE CONTROL
DVI-D OUT
1
If your TV has a component video
input, we recommend using it to
connect directly to the COMPO-
NENT VIDEO OUT of this player.
Use the standard 3-jack component
video output.
Connecting SCART and S-Video cables
SCART and S-Video cables will only plug in one way, so
make sure the plug is correctly lined up with the jack
before inserting. Be sure to fully insert for a good connec-
tion.
Note
The A/V EURO CONNECTOR connector can output composite,
S-Video or RGB component video. If you connect just one TV, use
the A/V EURO CONNECTOR connector. You can select the type
of video output by changing the Video Out setting in the Setup
Menu (page 124).
S-Video or composite video?
S-Video should give a better picture, so if you have an S-
Video input, use it. S-Video cables are available from any
good audio/visual dealer.
DVI output format (for NTSC replay)
System
Resolution
Vertical frequency
Horizontal frequency : 31.5 kHz
P
: Indicates Progressive (progressive scan)
NTSC : A broadcast format using primarily in Japan, the
28
U.S., Canada, Taiwan and Korea.
En
OPT.
COAX.
SURROUND
EXT. INT.
R
DIGITAL OUTPUT
COMPONENT
Y
C
/P
B
B
(HDCP)
3
: 525p (480p)/60
: 720 x 480
: 60 Hz
Important
Before making or changing any rear panel connections, make sure
that all components are switched off and unplugged from the wall
outlet.
FRONT
2
SUB WOOFER
CENTER
1
L
R
L
AUDIO OUTPUT
S1/S2
VIDEO
C
/P
1
2
R
R
A/V EUROCONNECTOR
VIDEO OUTPUT
If a SCART input is not available to you,
connect this player to your TV or AV
receiver using either the VIDEO or S1/
S2-VIDEO jacks.
Note
• The DVI output of this unit is HDCP compatible. When watching
DVI output images with this unit, it is necessary to use a TV or
display with HDCP compatible DVI input.
• There may be no Image output if connected to a TV or display
that is not compatible with the above format.
• When PAL progressive button is pressed, DVI cannot be output.
• Refer to the instruction manual of the TV or display to be
connected to this unit for detailed information regarding the DVI-
D terminal.
2
If your TV has a SCART input,
we recommend using it to
connect directly to the A/V
EURO CONNECTOR on this
player.
4
Plug into a standard
AC wall outlet.
Advertisement
Table of Contents
