Removing the PCI Card Cage
To remove the PCI cage from the server, perform the following steps:
Step 1. Lift up on the PCI card cage release lever and the back edge of the PCI card cage and lift the PCI
card cage out of the system.
Figure 1-26 Removing the PCI Card Cage
Removing the System Board
Step 1. Remove the power connector plate.
a. Unscrew the two power connector mounting screws on the back of the system.
b. Reach inside the system to remove the power connectors from the socket. The power connectors
will still be connected to their cables.
Step 2. Remove the VGA port mechanical cover located on the right side of the rear of the chassis (if
necessary). See Figure 1-27 for the location of the cover.
Step 3. Remove the DB9 port mechanical cover located on the MP area of the rear of the chassis (if
necessary). See Figure 1-27 for the location of the cover.
Chapter 1
HP Integrity rx2620 Upgrade
System Hardware Component Upgrade Instructions
Front of Chassis
39