Vga Module; Removing The Vga Module - Dell PowerEdge R450 Installation And Service Manual

Figure 91. Installing the internal USB card
Next steps
1. Follow the procedure listed in
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.

VGA module

This is a service technician replaceable part only.

Removing the VGA module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the front bezel.
4. Remove the backplane
5. Remove the air shroud.
6. Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the
jumpers and connecters
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Using Phillips #1 screwdriver, remove the screw on the VGA module.
2. Slide the module out of the system.
88 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
cover.
section.
system.
system.
System board