Programming The Remote Control - Sony BRAVIA KDL-40XBR9 Operating Instructions Manual

Programming the Remote Control

The remote control can be programmed to operate other equipment and is pre-programmed to
operate the following Sony equipment.
Function Button Sony Equipment Code Number
DVD
AMP
STB
Programming Other Equipment
Follow the steps below to program your TV remote control.
DISPLAY LIGHT POWER TV POWER
1
2
DVD AMP STB TV
FUNCTION
PREV REPLAY ADVANCE NEXT
PLAY
2
SYNC MENU PAUSE STOP
THEATER SCENE CC WIDE
WIDGETS
VIDEO
BRAVIA INTERNET
2
3
4
4
3
VOL CH
~
• Any of the FUNCTION buttons can be programmed to operate other equipment regardless of the labeling.
For example, DVD can be programmed to operate a Blu-ray Disc player.
Confirm the Programming
If you can turn your equipment on and off using the green POWER button, the programming is
complete. If not, try the next code listed.
~
• In some cases, you may not be able to program your remote control. If this is the case, use your equipment's
own remote control.
24
DVD Player 31033
Receiver 52172
Digital Satellite 01639
Find the code that corresponds to your equipment from page 25. If more
than one code is provided, try programming the first code listed.
Press and hold DVD, AMP or STB simultaneously with the INPUT button
and release. When in the programming mode, the FUNCTION button blinks
for approximately 30 seconds until a code is entered.
Enter the five digit code using 0-9 while the FUNCTION button is lit. If the
code is not entered within 30 seconds, you must repeat step 2.
Press or ENT to confirm the code. If successfully programmed, the
FUNCTION button blinks twice; if not, it blinks five times.