Service - Toro SL500 Operator's Manual

6. While sitting in the operator's position on the
tractor, start the engine and place the throttle lever
in the FAST (rabbit) position.
7. Move the tractor's PTO (Blade Engage) into the ON
position.
8. Remain in the operator's position with the cutting
deck engaged for a minimum of two minutes,
allowing the underside of the cutting deck to
thoroughly rinse.
9. Move the tractor's PTO (Blade Engage) into the
OFF position.
10. Turn the ignition key to the STOP position to turn
the tractor's engine off and engage the parking
brake.
11. Turn the water off and detach the hose coupler
from the water port on your decks surface.
Water Port
Figure 17
SECTION 9: SERVICE
Tires
WARNING:
inflation pressure shown on the sidewall of the
tire.
The recommended operating tire pressure is 10 psi for
the rear tires and 14 psi for the front tires. Do not
overinflate. Uneven tire pressure could cause the
cutting deck to mow unevenly.
Hose Coupler
(Shown without
Hose Attached)
Never exceed the maximum
Lubrication
WARNING:
inspecting, always disengage PTO, move
shift lever into neutral position, set parking
brake, stop engine and remove key to prevent
unintended starting.
Engine
Lubricate the engine with motor oil as instructed in the
Engine Owner's Manual packed with your unit.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system,
parking brake and lift linkage at least once a season
with light oil.
Front Wheels
Each of the front wheel axles is equipped with a grease
fitting. Lubricate with 251HEP grease or equivalent No.
2 multi purpose lithium grease after every 25 hours of
tractor operation. See Figure 18.
Axle Grease Fitting
Rim Grease Fitting
Fuse
A 20 amp fuse is installed in your tractor's wiring
harness to protect the tractor's electrical system from
damage caused by excessive amperage.
If the electrical system does not function, or your
tractor's engine will not crank, first check to be certain
that the fuse has not blown.
It can be found under the hood mounted between the
dash panel and fuel tank on the right-hand support bar.
Always use a 20 amp fuse for
IMPORTANT:
replacement.
22
Before lubricating, repairing, or
Figure 18