Changing Direction Of The Drain Hose - Samsung AR-KP/JP Series User & Installation Manual

Installing and connecting the drain hose of the indoor unit
Drain hose Extension
drain hose
6. Pass the drain hose under the refrigerant pipe, keeping the drain hose tight.
7. Pass the drain hose through the hole in the wall. Check if it slants
downwards as seen in the picture.
8. Using natural drainage method, check the drainage is normal.
• T he hose will be fixed permanently into position after finishing the installation and the gas leak test;
refer to page 46 for further details.
• M ake sure the installed direction of the drain hose is correct.
Inadequate installation may cause condensate water leakage.
• I f the drain hose is routed inside the room, insulate the hose so that dripping condensation does not damage
the furniture or floors.
• D O NOT WALL UP THE DRAIN HOSE CONNECTION !
Drain hose connection must be easy accessible and serviceable.

Changing direction of the drain hose

Change the direction only when it is necessary.
1. Detach the rubber cap with the plier.
2. Detach the drain hose by pulling it and turning to the right.
3. Insert the drain hose by fixing it with the screw into the groove of the drain
hose and the outlet of the drain pan.
4. Attach the rubber cap with a screwdriver by turning it to the left until it fixes
to the end of the groove.
5. Check for leakage on both side of the drain outlet.
Pour the water in direction of arrow.
• M ake sure the indoor unit is in upright position when you pour water to check for leakage.
Make sure that the water does not overflow onto the electrical part.
40~45 mm
Extension
Drain hose
drain hose
 Direction of the drained water
English-43
20 mm 20 mm
or more or more
Foam Insulation
Vinyl Tape
Shield
Drain hose Extension drain hose
Drain pan outlet
Screw hole
Screw
Drain hose
Rubber cap