Table of Contents
Advertisement
Outdoor Unit
Where it is not exposed to strong wind
Well ventilated and dustless places
Where possible keep out of sunlight and rain
Where neighbors are not annoyed by operation sound or hot air
f
Solid wall or support that prevents vibration and is strong enough to hold the product weight
Where there is no risk of flammable gas leakage
When installing the unit at a high place be sure to fix the unit legs
3 m or more away from the TV or radio (to prevent the screen from being distorted or noise from being generated)
Install the unit horizontally
Place where drained water does not become any problem.
Place with no plants (especially climbing plants) and where small animal can not access.
Outdoor unit should not be place higher than 2.4 m or directly under eaves for accessibility for service and OH&S reasons.
• Avoid the following places to prevent malfunction of the unit
- Where there is machine oil
- Where sulfide gas exists
Outdoor
Unit
Outer wall
Indoor
Unit
Cut insulation to
have rainwater
drained
Make an U-trap(A) on the
pipe (which is connected
to the indoor unit) at outer
wall and cut the bottom
part of the insulation (about
10 mm) to prevent rainwater
from getting inside through
the insulation. However,
be careful not to damage
the pipe.
The appearance of the unit may be different from the diagram depending on the model.
A
Wrap the refrigerant pipes
and the drain hose with the
absorbent pad and vinyl
tape. Refer to page 47 for
Make at least one round: It will reduce noise and vibration
- Salty environment such as seaside areas
- Other special atmosphere areas
125mm
or more
further details.
30 meters maximum
total pipe length
English-31
100mm or more
You can select the direction
of draining (left or right).
30 m as maximum pipe length
and 3 m as minimum pipe length
(It will reduce noise and vibration)
125mm
or more
15 meters
maximum
total pipe
length
Advertisement
Table of Contents
