Performing Several Commands In Sequence Automatically (Macro Play); Changing Receiver Settings - Sony RM-TP504 Primary Operating Instructions Manual

Performing Several
Commands in Sequence
Automatically (Macro Play)
The Macro Play function lets you link several IR codes in
sequential order as a single command. The remote
provides 3 macro lists (MACRO 1, 2 and 3). You can
specify up to 10 IR commands for each macro list.
1
Touch FUNCTION.
The FUNCTION screen appears.
2
Touch .
The MACRO screen appears.
When does not appear in the FUNCTION screen,
use the JOG DIAL to scroll through the list until it is
displayed, and then touch it.
• Touch SEND to operate Macro Play. The current command
is displayed in black. The finished commands are grayed
out.
BOX Number
Command
Category
• To cancel Macro Play, touch CANCEL. When Macro Play is
not operating, touching CANCEL returns to the
FUNCTION screen.
Notes
• For some models, the receiver cannot operate the Macro Play
commands as the time between each command is too short. In
this case, set "WAIT TIME" between each command. To set
"WAIT TIME", refer to "Macro Play setting" on page 25 and 26.
• For some makers other than Sony, there are some commands
that cannot be used in Macro Play.
16
Send key
Condition
Now Sending:
Outputting the command
Done!: Outputting is
finished

Changing receiver settings

You can set the receiver's audio input, or change the
brightness of the display.
1
Touch FUNCTION.
The FUNCTION screen appears.
2
Touch .
The CUSTOMIZE screen appears.
When does not appear in the FUNCTION screen,
use the JOG DIAL to scroll through the list until it is
displayed, and then touch it.
• To change the audio input of the function which is not
currently selected, touch FUNCTION.
• To change the audio input of the current function, touch
AUDIO SPLIT.
• To change the INPUT MODE of the current audio input,
touch AUDIO INPUT.
• To adjust the brightness of the display, touch DISPLAY
DIMMER.
3
Press the button or the
repeatedly until the desired setting appears.
button