Screen Setup - IRiver Kyobo Sam EB12 User Manual

Screen refresh
1. Refresh the screen by pressing and holding the [
more than 2 seconds.

Screen setup

Optimize the screen for reading by:
1. Press the [
2. Set up the desired line spacing, margins, and font.
Recharging by connecting with the computer
1. To recharge the device's battery, simply turn on the computer and
connect the device.
When an eBook is viewed continuously: up to ?? page views
On Standby: Approximately ?? weeks after full recharge
Use only the USB cable provided with the device. Unauthorized cables
may cause device malfunction.
Connect the provided cable to the high-power USB 2.0 port.
Connecting the cable to a low-power USB port (keyboard or USB hub
without power supply) may not recharge the device. Charging may be
interrupted when the computer switches to standby mode.
Recharge the device at room temperature. Recharging in excessively
hot or cold environments may adversely affect charging rate or
capacity. Battery life will gradually shorten after frequent recharges.
Recharge time will take ? hours and ?? minutes (when battery is fully
discharged and the power is off). Recharging while the device is in use
will increase the time necessary to achieve a full charge.
Recharge at least 10 minutes before turning the power on when the
battery is completely discharged and then reset the device by
pressing the [ ] key more than 10 seconds.
0 6 Gatting Started
] key will brings up a window for environment setup.
] key for