Change The Spark Plug - Simplicity 1695665 Manual

CHANGE THE SPARK PLUG

Remove the Snow Hood
To access the spark plug, the snow hood must be removed as
follows:
1. Remove the choke control knob (A A , Figure 20).
2. Remove the safety key (B B ).
3. Remove the mounting screws (C C ).
4. Slowly remove the snow hood (A A , Figure 21). Make sure that the
primer button hose and the ignition wire are not disconnected.
5. The spark plug (B B ) can now be accessed.
6. To install the snow hood, first make sure that the primer button hose
and the ignition wire are connected.
7. Mount the snow hood (A A , Figure 22) to the engine and secure with
the four mounting screws.
8. Align the tab (A A , Figure 23) on the choke control knob (B B ) with the
slot (C C ) in the snow hood.
9. Connect the choke control knob with the choke shaft. Make sure the
choke control knob is properly installed. If the choke control knob is
not installed correctly, the choke will not operate.
10. Reinstall the safety key (B B ).
A
Choke Knob Control
B
A
Snow Hood
B
A
Removing the Snow Hood
C
A
Figure 20
Connecting Choke Control Knob
23
MAINTENANCE
Figure 21
Figure 22
B
C
Figure 23