Intel H67 User Manual page 27

RAS# Active Time (tRAS)
Use this item to set row active time.
Write Recovery Time (tWR)
Use this item to set internal write to read command delay.
Row Refresh Cycle Time (tRFC)
Use this item to set minimum refresh recovery time.
Write to Read Delay (tWTR)
Use this item to set internal write to read command delay.
Active to Active Delay (tRRD)
Use this item to set row active to row active delay.
Read CAS# Precharege (tRTP)
Use this item to set read to precharge delay.
Four Active Windows Delay (tFAW)
Use this item to set four active windows delay.
►
USB Configuration
Legacy USB Support
The optional settings are: [Auto];[Disabled]; [Enabled].
EHCI Hand-off
The optional settings are: [Disabled]; [Enabled].
USB Hardware Delays and time-out
Use this item to set USB hardware time-out value for control, bulk, and interrupt
transfers.
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. 'Auto' uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
►
Super I/O Configuration
Serial Port
The optional settings are: [Disabled]; [Enabled].
Wake-up by PS/2 keyboard
Use this item to enable or Disable PS/2 keyboard wake-up from S3/S4/S5.
Wake-up by PS/2 mouse
Use this item to enable or Disable PS/2 mouse wake-up from S3/S4/S5.
PWRON After PWR-Fail
The optional settings are: [Always Off]; [Always On]; [Former-Sts].
EUP Support
Use this item to enable or disable EUP support.
- 22 -