Rheem Raypak D-2 Power Vent Installation And Operation Manual page 9

D-2 POWER VENT
009832 & 009833
N.O C
N.O
Figure 17. 240VAC
15. Reinstall the transformer cover. See Figure 14.
16. Install the left side outdoor conduit through the top
7/8" hole located on the left side of the heater. See
Figure 18.
NOTE: You must first remove the 7/8" plug on the heater
to install the conduit.
Figure 18. Wire Plumbing Location
17. Remove the (4) Phillips screws that hold the control
panel to the heater and lower the control panel.
Figure 19.
APPROVED
240VAC
FACTORY WIRED
240 VOLTS
TO CONVERT FOR
120V OPERATION
UNCONTROLLED DOCUMENT IF PRINTED
ACCESS
SCREW
ACCESS
SCREW
Figure 19. Control Panel Screw Location
18. Remove and replace the 7/8" plug with the provided
7/8" grommet (located on the left side of the control
panel). See Figure 20.
Figure 20. Grommet Location
NOTE: For Professional heaters, models 268 and 408, it
may be necessary to reroute the flexible conduit to either
side of the power vent.
19. Route the 24 VAC harness through the 7/8" grommet,
See Figure 21.
7/8" SUPPLIED
GROMMET
9