Rheem Raypak D-2 Power Vent Installation And Operation Manual page 7

Figure 6. Jacket Top Removal
Figure 7. Alternative Jacket Top Removal
NOTE: Brackets are positioned underneath the collar
adapter to capture the smaller model, See Figure 8.
Also note the orientation of the adapter on the heater as
shown in Figure 9.
BRACKETS USED ONLY ON
206/207/336/337 MODELS TO HOLD
COLLAR ADAPTER IN PLACE
Figure 8. Brackets, Models 206/207/336/337 Only
REAR OF
HEATER
Figure 9. Adapter Orientation
6. Lower the jacket top back onto the heater and reinstall
the (6) Phillips screws. See Figure 5.
APPROVED
FRONT OF
HEATER
UNCONTROLLED DOCUMENT IF PRINTED
7. If installing on a model 266, 267, 268, 406, 407 or
408 heater, skip step 8.
8. Turn the Power Vent upside down. Using a 5/16" nut
driver, relocate the mounting brackets as shown in
Figure 10.
Figure 10. Bracket Relocation
9. Place the Power Vent on top of the heater. See
Figure 11.
NOTE: Unit requires a minimum of 24" clearance
overhead.
Figure 11. Power Vent Location
10. Move the Power Vent, so that the collar adapter slips
into the Power Vent. See Figure 12.
Figure 12. Collar Adapter Location
BEFORE
AFTER
7