Save A Service Call - Rheem XWELL XC-10 Owner's Manual And Installation Instructions

Check the items below before making a service call. You will be charged for attending
to any condition or fault that is not related to the manufacture or failure of a part.
NO WATER FLOW FROM THE HOT TAP
Is the isolation valve open?

Check the isolation valve on the cold water line to the water heater is open?
Check if there is water available from other taps in the premises.
If water continues to not be available, phone a plumber.
WATER FROM HOT TAP IS NOT HOT OR NOT HOT ENOUGH
Is the electricity switched on?

Inspect the isolating switch marked "HOT WATER" or "WATER HEATER" at the
switchboard and at the isolating switch (if installed) near the water heater or
outside of the bathroom and ensure they are turned on.
Check the fuse or circuit breaker marked "HOT WATER" or "WATER HEATER"
at the switchboard.
Thermostat setting

Ensure the thermostat setting is appropriate. Adjust the temperature dial to gain
additional hot water capacity.
Refer to "Temperature Adjustment" on page 5.
Warning: Hotter water increases the risk of scald injury.

SAVE A SERVICE CALL

10