Safety Summary - ABB COPA-XM 3000 Series Instruction Manual

Series 10DX3000 Magnetic Flowmeter Instruction Manual

SAFETY SUMMARY

GENERAL
WARNINGS
SPECIFIC
WARNINGS
SPECIFIC
CAUTIONS
II
POSSIBLE PROCESS UPSETS
Maintenance must be performed only by qualified personnel and
only after securing equipment controlled by this product. Adjusting
or removing this product while it is in the system may upset the
process being controlled. Some process upsets may cause injury or
damage.
RETURN OF EQUIPMENT
All Flowmeters and/or Signal Converters being returned to the fac-
tory for repair must be free of any hazardous materials (acids,
alkalis, solvents, etc.). A Material Safety Data Sheet (MSDS) for all
process liquids must accompany returned equipment. Contact the
factory for authorization prior to returning equipment.
INSTRUCTION MANUALS
Do not install, maintain or operate this equipment without reading,
understanding and following the proper instructions and manuals,
otherwise injury or damage may result.
ELECTRICAL SHOCK HAZARD
Equipment powered by AC line voltage presents a potential electric
shock hazard to the user. Make certain that the system power is
disconnected from the operating branch circuit before attempting
electrical interconnections or service.
ELECTRICAL SHOCK HAZARD. Equipment powered by an AC line
voltage presents a potential electric shock hazard. Servicing of the
Magnetic Flow meter or Signal Converter should only be attempted
by a qualified electronics technician. (pg. 6-2)
ELECTRICAL SHOCK HAZARD. Equipment powered by an AC line
voltage presents a potential electric shock hazard. Make certain that
the system power is disconnected before making the following ohm-
meter checks. (pg. 6-3)
Do not use a DC ohmmeter for this measurement as polarization
effects will produce completely erroneous data. (pg. 4-3)
Some of the IC devices used in the signal converter are static
sensitive and may be damaged by improper handling. When adjust-
ing or servicing the signal converter, use of a grounded wrist strap
is recommended to prevent inadvertant damage to the integral solid
state circuitry. (pg. 6-1)