HDbaseT control function table
Control
Function
Side
Front-IR
(Wireless)
Rear-IR
(Wireless)
RS-232
RJ45/LAN
Wired Remote
HDBT-IR
(Wireless)
RS-232
RJ45/LAN
Wired Remote
O: Enable
X: Disable
Baud Rate
•
Press ◄/► to select RS-232 baud rate. The rate is fixed at 9600 for HDBaseT mode. The
baud-rate option is only available when a 9-pin RS-232 connector is in use.
•
Test Pattern
Press ◄/► to select the test pattern. The options are Off, Grid, White, Red, Green, Blue,
Black, RGB Ramps, Color Bar, Step Bars, CheckBoard, Horizental Lines, Vertical Lines,
Diagonal Lines, Horizontal Ramp and Vertical Ramps.
Image Memory
•
To enable users to save and apply a set of image settings customized for regularly used
circumstance by source and timing
•
12V Trigger
Press ◄/► to enable or disable 12V trigger function.
Standby Settings
•
Press ENTER to enter the Standby Settings menu. See
page 56
for more details.
•
Network Settings
Press ENTER to enter the Network Settings menu. See
page 56
for more details.
Reset All Settings
•
Press ENTER to reset all settings to default value.
Standby Mode
Eco
Network
(< 0.5W)
(<2W)
O
O
O
O
O
O
X
O
O
O
X
X
X
X
X
X
X
X
Remark
Normal
(>2W)
O (Can disable
by OSD)
O (Can disable
by OSD)
X
X
O
O
O
O
User can connect wired
O
remote at HDBaseT TX side
to get the wired function.
"Standby Settings menu" on
"Network Settings menu" on
53