Mercedes-Benz Mercedec-AMG GT R Owner's Manual page 155

152 Driving and parking
Parking Assist PARKTRONIC warning display (vehi‐
cles with front and reversing camera)
If Parking Assist PARKTRONIC detects an obsta‐
cle in the path of the vehicle, a pop-up window
with the appropriate warning display appears in
the media display at speeds below approx‐
imately 10 km/h.
The coloured segments show the distance
between the sensors and the obstacle detected:
1 Yellow warning display: obstacles at a dis‐
tance between approx. 0.6 m and 1.0 m
2 Orange warning display: obstacles at a
medium distance between approx. 0.3 m
and 0.6 m
3 Red warning display: obstacles at a very
short distance of approx. 0.3 m or less
When Parking Assist PARKTRONIC is operational
and no object is detected, no segments are
shown in the warning display.
% If the entire system fails, the internal seg‐
ments of the warning display are shown in
red and the é symbol appears in the mul‐
tifunction display in the instrument cluster.
If Parking Assist PARKTRONIC is deactivated,
the warning display fades out.
In the standard setting, an intermittent warning
tone sounds from a distance of approximately
0.3 m to an obstacle in front and approximately
1.0 m to an obstacle behind. A continuous warn‐
ing tone sounds from a distance of approx‐
imately 0.2 m. Using the Warn early setting, you
can set the warning tone in the multimedia sys‐
tem so that it will sound earlier at a greater dis‐
tance of approximately 1.0 m (
% The Warn early setting is always active in
the rear of the vehicle.
System limits
Parking Assist PARKTRONIC does not necessa‐
rily take into account the following obstacles:
Obstacles below the detection range, e.g.
R
persons, animals or objects.
Obstacles above the detection range, e.g.
R
overhanging loads, overhangs or loading
ramps of lorries.
As a result of additional accessories (e.g. licence
plate bracket or bicycle rack) the actual distance
to an obstacle may not correspond to the dis‐
tance measured by Parking Assist PARKTRONIC
under certain conditions.
The sensors must be free of dirt, ice and slush.
Otherwise, they may not function correctly.
Clean the sensors regularly, taking care not to
scratch or damage them.
page 153).
/