Whirlpool WGG745S0FE Owner's Manual page 9

In Canada, the installation of this range must conform with the
current standards CAN/CSA-Z240.1-latest edition, or with local
codes.
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm)
countertop height.
IMPORTANT: If installing a range hood or microwave hood combination above the cooking surface, follow the range hood or microwave
hood combination installation instructions for dimensional clearances above the cooktop surface. Range may be installed with zero
clearance to combustible construction at the rear and on the sides below the cooktop.
18" (45.7 cm) upper cabinet to countertop
A.
13" (33.0 cm) upper cabinet depth
B.
30" (76.2 cm) minimum opening width
C.
For minimum clearance to the top of the cooktop, see NOTE.
D.
in U.S.A.: 30" (76.2 cm) minimum opening width
E.
in Canada: 31" (78.7 cm) minimum opening width
3" (7.6 cm) minimum clearance from both sides of the range to the side wall or other combustible material.
F.
Cabinet door or hinges should not extend into the cutout.
G.
3" (7.6 cm) distance from wall
H.
1 1 / " (3.8 cm) minimum from right side cabinet
I.
2
8" (20.3 cm) width
J.
7" (17.8 cm) minimum from floor
K.
2" (5.1 cm) minimum from floor
L.
*Drill on centerline 1 1 / " (3.2 cm) from rear wall for gas supply line.
4
**Gas lines must be installed within the shaded area to ensure proper alignment of this oven with cabinets.
***Electrical plugs must be installed within the shaded area to ensure proper alignment of this oven with cabinets.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is covered by not less than 1/4" (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm)
copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.
Mobile home installations require:
■ When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing the
range is adequate as long as it conforms to the standards
listed above.
■ Four-wire power supply cord or cable must be used in a mobile
home installation.
9