Indicator Installation - Detecto 8432-CH Owner's Manual

Indicator Installation

First, install the scale cable on the indicator. Align the scale cable connector with the jack on
the back of the indicator, then gently push the connector onto the jack. Refer to Figure No. 3
for the location of the scale cable jack.
Using a small flat blade screwdriver, tighten the screws on both sides of the scale cable
connector.
Next, install the indicator on the scale column bracket by placing the screw heads on the
back of the indicator into the large end of the slotted holes in the bracket.
Pull down on the indicator to secure it to the bracket. The spring plunger will lock the
indicator to the bracket. See Figures No. 3, 4, and 5.
Figure No. 3
AC Power Adapter
4
SCALE ASSEMBLY, CONT.
Scale
Cable
RS232
Port
8525-0377-0M Rev A 8432-CH Owner's
Spring
Plunger
Figure No. 4
Spring
Plunger
Release
Figure No. 5