Installation; Unpacking; Assembly; Placing The System - Detecto HealthySole Plus Owner's Manual

Table of Contents

Advertisement

Unpacking

Carefully remove the HealthySole® Plus System from the shipping carton and inspect it for
any damage that may have taken place during shipment. Keep and use the original carton
and packing material for return shipment if it should become necessary. The purchaser is
responsible for filing all claims for any damages or loss incurred during transit. Remove all
plastic wrapping, foam fillers and cardboard material from system base, column with display
and other components. You should have the following components:
Column with attached Display
System Base (with Dust Cover, Dust Shield and Base Cover pre-installed)
System Sight Shield
Hardware pack – 2, 1/4-20 x 1/2 Philips head screws
AC Power Cord

Assembly

1. Place system base on level floor.
2. Evenly loosen both column clamp knobs.
3. Align column with opening in system base and insert column into system base.
4. Tighten both column clamp knobs evenly to secure column to system base.
5. Align the holes in the system sight shield with the holes on the rear of the system base
cover and secure with two Philips head screws.

Placing the System

For indoor use only.
Place the system on a flat, level floor or low-cut carpet away from heating and cooling
vents.
Make certain the power cord is out of the way of normal traffic to avoid a trip hazard.
System is designed to operate within a temperature range of 55 to 90 °F (13 to 32 °C).
Suitable for dry environments only RH < 90% and non-condensing environments.
NEVER allow system to get wet.
NEVER use around corrosive chemicals or products.
Explosion hazard - Do not place in an oxygen or flammable environment.

AC Power Connection

To power the system, connect the plug from the AC power cord into the power connector on
the back of the system base and then plug the AC power cord into the proper electrical
outlet. On models requiring 230 VAC, it is the customer's responsibility to obtain the correct
power adapter plug.
6

INSTALLATION

3300-0196-0M Rev A 05/16

Advertisement

Table of Contents
loading

Table of Contents