Table of Contents
Advertisement
STEP 3 – SIDE OF THE HEAD
•
With the comb set at 3 mm or 6 mm, trim sideburns. Then change to the longer 9 mm
guide comb and continue to cut the top of the head.
STEP 4 – TOP OF THE HEAD
•
Use the longer length comb attachment and set it to 24 mm or 27 mm then cut hair on
top of the head against the direction in which the hair normally grows.
•
For longer hair on top, use the longer length comb attachment (25 – 35 mm) to achieve
the desired style.
•
Always work from the back of the head.
STEP 5 – THE FINISHING TOUCHES
•
Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
•
To produce a clean straight line at the sideburns, reverse the hair clipper.
•
Place the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
MICRO FADE ADJUSTABLE COMB
The micro fade adjustable comb allows precision cutting in the 1 to 5 mm range.
Use the adjustment dial to set the comb to the desired length.
AUTO TURBO SYSTEM
•
When switched on, your clipper runs in normal mode. The Auto Turbo feature will
automatically activate when the clipper senses it needs more power.
•
To run in Turbo mode, slide the on/off switch to the turbo position.
CARE FOR YOUR HAIRCLIPPER
•
Your clipper is fitted with high quality blades.
•
To ensure long lasting performance of your clipper, clean the blades and unit regularly.
•
Always keep the attachment guide comb on the trimmer blade.
AFTER EACH USE
•
Ensure the appliance is switched off and unplugged from the charger before cleaning.
•
Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
•
To clean unit, wipe with a damp cloth and dry immediately.
•
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
WASHABLE BLADE CLEANING
•
This clipper is fully washable and therefore can be rinsed under a running tap.
•
To remove the blades ensure the unit is switched off. Push the blade set away from the
clipper body using your thumb (Fig A).
•
To reattach once the blades are cleaned and dry, align the bottom of the blade with
the bottom blade housing tab and slide the cartridge back into place until you hear a
click.
7
Advertisement
Table of Contents
