Table of Contents
Advertisement
1-3. Installation
5. Connect the two harnesses (supplied with BKP-7312)
to connectors CN3 and CN4 on the BKP-7312 respec-
tively.
6. Install the Shielding case (A) assembly (supplied with
BKP-7312) to the rear panel.
7. Fit the BKP-7312 with the A side face up to the rear
panel using the four supports. Apply locking com-
pound to the four supports.
Harness
BKP-7312
CN4
Shielding case(A)
8. Disconnect the connector CN12 on the MB-563 board.
Attach the ferrite core to the coaxial cable as the
figure. Connect the connector CN12 to the MB-563
board.
MB-563 board
Coaxial cable
CN12
1-8
CN3
A Side
Support
Rear Panel
Ferrite core
Rear panel
9. Connect the other ends of the harnesses to the connec-
tors CN26 and CN28 on the MB-563 board respective-
ly.
10. Connect the two flexible card wires to the connector
CN4 on the CN-1014 board and the connector CN3 on
the CN-1049 board.
n
When connecting the flexible card wires, refer to "2-1-
3. Disconnecting/Connecting of Flexible Card Wire."
Flexible card wire
MB-563 board
CN28
CN26
Flexible card wire
CN-1014 board
CN4
11. Install the Shielding case (B) assembly (supplied with
BKP-7312) to the BKP-7312 with the four screws
(+PWH2.6x4).
12. Install the rear panel with the six screws (+B3x5).
Shielding case(B)
PWH 2.6 × 4
B3 × 5
CN-1049 board
CN3
Rear panel
B3 × 5
B3 × 5
Rear panel
CCU-700A(UC)
CCU-700AP(CE)
Advertisement
Table of Contents
