Globug light tower mount type balloon light (52 pages)
Summary of Contents for MULTIQUIP MLT
Page 1
OPERATION AND PARTS MANUAL MODULAR LIGHT TOWER (MLT) USED WITH THE FOLLOWING GENERATORS/WELDERS: DA7000SS KD-1800 KD-6 SDW-225 Revision #5 (08/15/08) To find the latest revision of this publication, visit our website at: www.multiquip.com P/N 29210...
If you believe that your vehicle has a defect that could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying Multiquip at 1-800-421-1244. If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign.
, 2006 Order via Internet (Dealers Only) Best Deal! If you have an MQ Account, to obtain a Order parts on-line using Multiquip’s SmartEquip website! Username and Password, E-mail us at: ■ View Parts Diagrams parts@multiquip.com. ■ Order Parts To obtain an MQ Account, contact your ■...
You CAN be injured if you DO NOT follow directions. Rotating Parts Potential hazards associated with the MLT Light Tower NEVER operate equipment with covers, operation will be referenced with Hazard Symbols which appear or guards removed. Keep fingers, hands,...
Page 7
MODULAR LIGHT TOWER — SAFETY MESSAGE ALERT SYMBOLS QP-202TH — SAFETY MESSAGE ALERT SYMBOLS Accidental Starting Respiratory Hazard ALWAYS place the power source, circuit breakers or ON/OFF switch in the OFF ALWAYS wear approved respiratory position, when the generator is not in use, protection.
Also keep the immediate area free of ■ NEVER use accessories or attachments, which are not bystanders. recommended by Multiquip for this equipment. Damage to the equipment and/or injury to user may result. ■ ALWAYS use a trained technician to install and remove a ■...
Page 9
MODULAR LIGHT TOWER — RULES FOR SAFE OPERATION DANGER DANGER: DANGER DANGER DANGER DANGER The 6 DANGER items listed below are considered high DANGER areas and should To prevent serious injury be adhered to. Failing to understand these or death , ALWAYS make areas could result in bodily harm electrical sure area above trailer is...
— MODULAR LIGHT TOWER OPERATION AND SAFETY DECALS Machine Safety Decals This modular light tower is equipped with a number of safety decals. These decals are provided for operator safety and maintenance information. The illustration below and on the next page shows these decals as they appear on the machine. Should any of these decals become unreadable, replacements can be obtained from your dealer.
The Multiquip modular light tower is a general purpose floodlight tower intended for emergency and remote lighting conditions. This modular light tower (MLT) can be configured to operate with four different types of power sources: The DA-7000 , KD-6 , KD-1800 generators or the SDW-225SS welder/generator.
MODULAR LIGHT TOWER — COMPONENTS Figure 3. Components Figure 3 shows the location of the controls and components Jack Stands – There are two trailer jack stands, which for the Modular Light Tower. The functions of each control is are located at the front and rear of the trailer. Use these described below: 2 jack stands to level and support the light tower.
MODULAR LIGHT TOWER — TRAILER SAFETY GUIDELINES Frame Length – This measurement is from the ball hitch Trailer Safety Precautions to the rear bumper (reflector). CAUTION : CAUTION : CAUTION : CAUTION : CAUTION : Frame Width – This measurement is from fender to fender.
Page 23
MODULAR LIGHT TOWER — TRAILER SAFETY GUIDELINES c i l " 8 MODULAR LIGHT TOWER — PARTS & OPERATION MANUAL — REV. #5 (08/15/08) — PAGE 23...
Page 24
MODULAR LIGHT TOWER — TRAILER SAFETY GUIDELINES c i l ) t ' " 2 X " " 0 B " X " " 5 B " X " " 5 B " " 5 B " " 5 " 2 X "...
Page 25
MODULAR LIGHT TOWER — TRAILER SAFETY GUIDELINES Brakes Figure 8 display's the major electric brake components that will require inspection and maintenance. Please inspect If your trailer has a braking system, the brakes should be these components as required. Reference Table 7 for elec- inspected the first 200 miles of operation.
Page 26
MODULAR LIGHT TOWER — TRAILER SAFETY GUIDELINES Figure 8. Electric Brake Components Hydraulic/Air/Surge Brakes Figure 9 below display's the major hydraulic/air/surge brake Hydraulic brakes (Figure 9) should not require any special components that will require inspection and maintenance. attention with the exception of routine maintenance such as Please inspect these components as required using steps shoe and lining replacement.
Page 27
MODULAR LIGHT TOWER — TRAILER SAFETY GUIDELINES Tires/Wheels/Lug Nuts Tires and wheels are a very important and critical compo- nents of the trailer. When specifying or replacing the trailer wheels it is important the wheels, tires, and axle are prop- erly matched.
Page 28
MODULAR LIGHT TOWER — TRAILER SAFETY GUIDELINES e t I ) . s " 8 " 6 " 2 Lug Nut Torque Requirements It is extremely important to apply and maintain proper wheel mounting torque on the trailer. Be sure to use only the fas- teners matched to the cone angle of the wheel.
MODULAR LIGHT TOWER — T-BAR INSTALLATION CAUTION: CAUTION: CAUTION: CAUTION: CAUTION: Indoor Installation Exhaust gases from gasoline engines are extremely Pay close attention to ventilation when poisonous. Whenever an engine is installed indoors the operating the generator in enclosed areas. exhaust fumes must be vented to the outside.
MODULAR LIGHT TOWER — TOWER MAST PRE-SETUP WARNING: WARNING: WARNING: WARNING: WARNING: Mast (Top and Center Tower Sections) Once the tower mast has been locked into its vertical position, ALWAYS check overhead for clearance of the the top and center tower sections can now be raised. These two mast.
MODULAR LIGHT TOWER — ENGINE PRE-SETUP WARNING: WARNING: WARNING: WARNING: WARNING: Starting NEVER operate the light tower with the engine compart- The engine's exhaust contains harmful emissions. ALWAYS ventilate the ment doors open. Operation with the doors open may cause exhaust when operating inside tunnels, insufficient cooling to the unit, and damage may result.
MODULAR LIGHT TOWER — OPERATION Operation 3. Set circuit breaker CB-1 (page 41) on the ballast box to the ON position. Proceed with this section only if the following have been completed: 4. Wait a few minutes for the ballast to activate. Observe that flood lights #1 and #2 are ON.
MODULAR LIGHT TOWER — MAINTENANCE Check Cable Wear The mast sections, latches, cable clamps, pulleys, etc. should be inspected at this time and repaired or replaced as The wire rope (cable) that raises and extends the mast is a necessary. There are a total of 4 pulleys. They should be very important part of the light tower.
MODULAR LIGHT TOWER — PREPARATION FOR LONG -TERM STORAGE Generator Storage For storage of the generator for over 30 days, the following is required: Drain the fuel tank completely. Run the engine until all the fuel is completely consumed. Completely drain the oil from the crankcase and refill with fresh oil.
MODULAR LIGHT TOWER — TROUBLESHOOTING x i f h c i i t a . y l r . y r t f i i c r o t t . y l r o f v i t i l d .
Page 39
MODULAR LIGHT TOWER — TROUBLESHOOTING s t r r t s e k i e v i r o f i r e r e t t i w t s r i k c a t l a l l .
Page 40
MODULAR LIGHT TOWER — TROUBLESHOOTING TROUBLESHOOTING GUIDE Use the following procedure to determine which of the four floodlights is not functioning: Connections: 1. Make sure that floodlight #1 power cable is plugged into the J1 connector on the T-Bar assembly. 2.
Multiquip. A blank entry generally indicates that the item is not sold separately or is not sold by Multiquip. Other entries will be clarified in the “Remarks” Column. PAGE 44 — MODULAR LIGHT TOWER — PARTS & OPERATION MANUAL — REV. #5 (08/15/08)
MODULAR LIGHT TOWER — NAME PLATE AND DECALS NAME PLATE AND DECALS PAGE 46 — MODULAR LIGHT TOWER — PARTS & OPERATION MANUAL — REV. #5 (08/15/08)
Page 47
MODULAR LIGHT TOWER — NAME PLATE AND DECALS NAME PLATE AND DECALS PART NO PART NAME QTY. REMARKS B9504000304 DECAL: CAUTION HOT PARTS B90400030 19655 DECAL: DANGER HIGH VOLTAGE DCL111 DECAL: INSERT FORKS 24" 13118 DECAL: POWDER COATED DCL109 DECAL: WARNING NON VERT. TOWER 1 DCL104 DECAL: RING PIN DCL117...
MODULAR LIGHT TOWER — POWER CABLE ASSY. POWER CABLE ASSY. PAGE 72 — MODULAR LIGHT TOWER — PARTS & OPERATION MANUAL — REV. #5 (08/15/08)
Page 73
MODULAR LIGHT TOWER — POWER CABLE ASSY. POWER CABLE ASSY. PART NO PART NAME QTY. REMARKS 19798 CABLE ELEC 10 AWG X 4 ........ 1 ....COND-600V 10105 TERMINAL, RING 12-10, #10 INS 29069 TERMINAL, RING 10-12AWY X 3/8 IN 19686 PLUG, LOCKING ..........
TERMS AND CONDITIONS OF SALE — PARTS PAYMENT TERMS Parts must be in new and resalable con- Multiquip reserves the right to quote and sell dition, in the original Multiquip package (if direct to Government agencies, and to Original Terms of payment for parts are net 30 days.