Charging Indicator Lights - Remington Omniblade Multi-Pro Quick Start Manual

Hide thumbs Also See for Omniblade Multi-Pro:
Table of Contents

Advertisement

CHARGING YOUR APPLIANCE
It is recommended to fully charge your appliance before using it for the first time.
1. Ensure the product is switched off.
2. Connect the product to the USB cable and then to the USB end of the cable to a powered
USB port.

CHARGING INDICATOR LIGHTS

Charging
The lights will come in a
repeating sequence from
bottom to top while
charging.
Light off
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains supply.
To preserve the life of your batteries, let them run out every 6 months then recharge for 2
hours.
Run time from fully charged is up to 60 mins.
ATTACHMENTS
TO FIT AND REMOVE ATTACHMENTS (FIG. B)
Ensure that the device is switched off before fitting or removing attachments.
To remove, rotate the attachment anti-clockwise until it unlocks and then lift it off.
To fit, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.
Fully charged
5 min
All lights will stay on for 5
minutes then go out.
Light on
Battery Low
The bottom light will flash
for 5 seconds.
Light flashing
GB
AE
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hg5000

Table of Contents