Configuration User Interface - Meinberg IMS-M3000 Manual

8 Configuration User Interface
There are several ways to configure the LANTIME parameters:
Command Line Interface (CLI) via TELNET
Command Line Interface via SSH
Command Line Interface via serial terminal in front panel
(38400/8N1/VT100)
HTTP Interface
Secure HTTP Interface (HTTPS)
Front panel LCD/VFD Interface (except LANTIME M100)
SNMP Management
In order to be able to configure the time server via the web interface or a telnet/SSH connection, an IP address
has to be assigned via the front panel keys and LC/VF display (for automatic assignment possibilities please
refer to: DHCP IPv4 or AUTOCONF IPv6). LANTIME variants without a display can be configured using the
serial terminal interface (labeled "Term" or "Terminal") The termin program should be set to 38400Baud / 8N1
– VT100 emulation. Once the IPv4 address, net mask and IPv4 GATEWAY have been set up or the network
interface has been automatically configured with DHCP/Autoconf, further configuration changes can be done
via a network connection:
To set up a TELNET connection the following commands are entered (replace 198.168.10.10 with the IP of
your LANTIME):
telnet 198.168.10.10 // LANTIME IP address
user: root
password: timeserver
With "setup" the configuration program is started.
To set up a SSH connection the following commands are entered:
ssh root@198.168.10.10 // LANTIME IP address
password: timeserver
With "setup" the configuration program is started.
To set up a HTTP connection the following address is to enter in a web browser:
http://198.168.10.10 // LANTIME IP address
password: timeserver
To set up a Secure HTTP (HTTPS) connection the following address is entered in a web browser:
https://198.168.10.10 // LANTIME IP address
password: timeserver
IMS-M3000 Date: 21st August 2019
8 Configuration User Interface
15