Table of Contents
Advertisement
Manual Switch Installation for Maxitrol Units
The manual ON/OFF switch for the fireplace comes semi-installed. All that is needed is to install the switch
itself to the surround backing plate.
Figure 91: Pre-installed ON OFF
switch assembly.
To install ON/OFF Switch
1. Check that the ON/OFF Switch cable is plugged into the Maxitrol module as shown in (Figure 92).
Figure 93: Positioning the switch behind the backing plate opening slot.
100000300 051119-48
Figure 92: Switch connector at control module.
2. Position the ON/OFF switch against
37
the open slot on the surround backing
plate. Be sure to orient the switch as
shown in (Figure 93).
i40 TOFINO
Advertisement
Table of Contents
