Remove the jumper between P1 and P/+ to connect the DC reactor.
*2
Terminal input specifications can be changed by analog input specification switchover (Pr.73, Pr.267). To input voltage, set the voltage/current
input selection switch to "V". To input current, set the switch to "I". The initial setting varies depending on the specification. (Refer to the FR-E800
Instruction Manual (Function).)
*3
It is recommended to use 2 W 1 kΩ when the frequency setting signal is changed frequently.
*4
The function of these terminals can be changed using the Pr.192 ABC??????.