Ethernet Connector (Ethernet Model / Safety Communication Model) - Mitsubishi Electric 800 Series Instruction Manual

2.8.2 Ethernet connector (Ethernet model / Safety
communication model)
 Ethernet communication specifications
Item
Category
Data transmission speed
Transmission method
Maximum segment length
Number of cascade connection
stages
Topology
Interface
Number of interfaces available
IP version
 Connection cable
Use Ethernet cables compliant with the following standards.
Ethernet cable
Category 5 or higher straight cable (double
shielded / STP)
• Recommended product (as of April 2019)
Model
Mitsubishi Electric System & Service
*1
SC-E5EW series
Co., Ltd.
*1 SC-E5EW cable is for in-enclosure and indoor uses. SC-E5EW-L cable is for outdoor use.
NOTE
• Depending on the cable connector shape, the cable may not be connected to the inverter.
 Hubs
Use hubs that meet the following conditions. Operation is not guaranteed if the hubs do not meet these conditions.
• Compliance with the IEEE 802.3 (100BASE-TX)
• Support of the auto MDI/MDI-X function
• Support of the auto-negotiation function
• Switching hub (layer 2 switch)
*1 A repeater hub is not available.
Industrial switching hub
Model
NZ2EHG-T8N
NZ2EHG-T8 (discontinued
product)
DT135TX
NOTE
• Do not connect the FR-PA07, FR-LU08, FR-PU07, or any other operation panel or parameter unit to the Ethernet port. Doing
so may damage the inverter.
• For CC-Link IE TSN communication, the hubs can be used only for connection with units compliant with the authentication
class A.
Description
100BASE-TX/10BASE-T
100 Mbps (100BASE-TX) / 10 Mbps (10BASE-T)
Baseband
100 m between the hub and the inverter
Up to 2 (100BASE-TX) / up to 4 (10BASE-T)
Line, star, or a combination of line and star
RJ-45
2
IPv4
Connector
RJ-45 connector
Manufacturer
*1
Manufacturer
Mitsubishi Electric Corporation
Mitsubishi Electric Corporation
Mitsubishi Electric System & Service Co., Ltd.
The following conditioning cables:
• IEEE 802.3 (100BASE-TX)
• ANSI/TIA/EIA-568-B (Category 5)
2.8 Communication connectors and terminals
Type
2. Installation and Wiring
1
2
3
4
5
6
7
8
9
10
67