Vizio Elevate P514a-H6 User Manual page 22

Mode & Level Settings
Function
Speaker Test
Spkr Test
VIZIO Remote
VZtvRmt
Wi-Fi Setup
WiFi Setup
Elevate Height
Speakers
Elvate
Surround Sound
Surnd
ENG - 22
LED Behavior
SETUP > Spkr Test > OK to activate the speaker test function. A voice will begin calling out
each speaker beginning with left front (Left Front, Center, Right Front, Right Rear, Left Rear,
— Left Front Height, Right Front Height, Right Rear Height, Left Rear Height and subwoofer-
white noise). If any of these are missing, check the connection and run the speaker test
function again.
Remote On
SETUP > VZtvRmt > Use the Next/Previous buttons to enable/disable VIZIO TV
Remotes. When enabled (On), you can use a VIZIO TV remote control to turn on the sound
bar (using the TV Volume Up button) and control volume.
Remote Off
SETUP > WiFi Setup > Use the Next/Previous buttons to enable/disable Wi-Fi setup on
Single LED indicator
your sound bar. Press the OK button to select.
with sound
Wi-Fi setup allows the VIZIO SmartCast Mobile
confirmation.
paired Bluetooth devices in the event of a lost connection or if a new device is being paired.
EFFECT > Elvate > Use the Next/Previous buttons to toggle between preset height modes.
When Up is selected, front height speakers will rotate up to provide an immersive movie
sound experience. When Wide is selected, the front height speakers will rotate forward (good
for listening to music). The Auto setting will adjust height speakers based on content.
Note: Default setting is up.
EFFECT > Surnd > Use the Next/Previous buttons to enable/disable surround sound and
front or dual modes. When enabled (On), Dolby and DTS Surround content will produce full
5.1 sound. With stereo content, EQ Music will produce DTS Virtual:X enhanced sound and
EQ Movie will produce realistic 5.1 effect sound. When disabled (Off), the surround speakers
will be disabled and the sound bar will only produce DTS Virtual sound effect.
Dual - Both surround speakers will play the same left and right channel content as the
sound bar.
Note: With stereo content, if EQ mode is set to Direct and Surround is set to Off, the sound
bar will output 2.1 audio without center or surround.
Description
app to reconnect the sound bar to Wi-Fi or
™