Install Further Cabinet Rows; Align Cabinets; Figure 57: Locking Two Modules; Figure 58: Cabinet Alignment Brackets - NEC FE Series User Manual

Install Further Cabinet Rows

Install the Cabinet hanger pins (see 6.3.1).
Use the grip handles on the cabinet (Figure 51 in chapter 6.3.2, A) to bring it into
position at left corner on the first cabinet row.
Align together the Cabinet hanger pins with the frame support sockets (Figure 51, B)
and the Corner alignment pins on the cabinet below (Figure 51, C).
Lower the cabinet onto the Power supply socket (Figure 51, D), gently pressing it
until it sits firmly.
Notice
Place the cabinet carefully and straight on top of the Power supply socket. Otherwise, the
connection may be pushed out and not function properly.
Install further cabinets until a row is complete.
Connect each cabinet to its adjacent cabinets
with the Screw connections.
Place a delivered Allen screw (E) in the
screw connection anchor.
Only finger-tighten the screw to the
Counter plate (F) in the other cabinet.
Notice
Do not tighten the Screw connection too much.
Otherwise the cabinets cannot be aligned later on.
For the top row, use type B cabinets only.
Proceed as described above.

Align Cabinets

After all rows of cabinets are installed, the cabinets have to be aligned with the Cabinet
alignment brackets.
For each cabinet junction, attach one Cabinet
alignment bracket (A) with four screws, one
on each cabinet.
Attach Cabinet alignment brackets also on the
sides of the LED Wall (B) and at the bottom
over the Power bar (C).
After each cabinet junction has a Cabinet
alignment bracket, tighten all Screw
connections hand tight.
By tightening the Screw connections properly,
the cabinets keep their aligned position.
Remove all Cabinet alignment brackets.
E F

Figure 57: Locking Two Modules

C
B

Figure 58: Cabinet Alignment Brackets

© NEC Corporation 2019
Commented [A3]: Doctima @NEC: It this note
relevant for FE?
A
45