System-Board Shield; Removing The System-Board Shield - Dell OptiPlex 7480 All-In-One Service Manual

Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
NOTE: Repeat step 1 and 2 if there are two memory modules.
3. Align the tabs on the DIMM door with the slots on the system-board shield and snap into place.
Next steps
1. Install the back cover.
2. Install the cable cover (optional).
3. Install the stand.
4. Follow the procedure in

System-board shield

Removing the system-board shield

Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the cable cover
4. Remove the back cover.
About this task
The following image indicates the location of the system-board shield and provides a visual representation of the removal procedure.
28 Removing and installing components
After working inside your computer.
Before working inside your
(optional).
computer.