Table of Contents
Advertisement
About this task
The following image indicates the location of the side-I/O board and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes on the side-I/O board with the screw holes on the display-assembly base.
2. Replace the two screws (M2.5x3.5) to secure the side-I/O board to the display-assembly base.
3. Route the SIO-signal cable, SIO-power cable, and audio-board cable through the routing guides on the display-assembly base.
4. Connect the SIO-signal cable, SIO-power cable, and audio-board cable to the system board.
5. Align the screw holes on the side I/O-board shield with the screw holes on the display-assembly base.
6. Replace the two screws (M3x5) to secure the side I/O-board shield to the display-assembly base.
Next steps
1. Install the
rear-I/O
bracket.
2. Install the
bottom
cover.
3. Install the
system-board
4. Install the
back
cover.
5. Install the
cable cover
(optional).
6. Install the stand.
7. Follow the procedure in
76
Removing and installing components
shield.
After working inside your
computer.
Advertisement
Table of Contents
